Premier ULTRA 5 User Manual download pdf (Page 15)

USER MANUAL PREMIER & ULTRA SERIES

The function values in a selected program number can be changed using either manual or automatic programming. For units,

range and limits of the function values refer to the previous chapter, MACHINE CONTROL PANEL.

10 programs can be selected and set, number 0 to 9. Note: program 0 cannot be programmed. The values in this program are

set for service and reference use.

MANUAL PROGRAMMING

Starting situation: machine is in normal operation mode and the lid is open.

A. Select the correct program with PROG 0-9 key for setting function values.

Program number is displayed on the small display.

Press REPROG key to switch into program mode.

The program number now starts to blink on the small display.

VACUUM

GASFLUSH

SEAL

SOFT-AIR

Select the required function for programming with the FUNCTION SELECT Key.

The indicator lights will turn on for the active functions when selected.

Remark on Seal function for option 1-2 cut-offseal

At option 1-2 cut-offseal, the indicator SEAL lights up twice when selected

The ﬁ rst time is for setting the seal time and the second time for setting the cutting time.

Remark on option Digital Sensor Control

At option sensor control, the indicator VACUUM lights up twice when selected.

The ﬁ rst time for the vacuum function (vacuum percentage)

The second time for the vacuum plus function (time duration), see pages 11,13

VAC

STOP

Digital Time Control

Set the amount of time required for the selected function by using the + and – keys.

Digital Sensor Control

Set the percentage of vacuum required or the amount of time required for the selected

function by using the + and – keys.

Remarks

Set values are displayed on the large display. The functions vacuum plus (sensor control),

gas ﬂ ush and soft air can be turned off in the programme if required. For turning off a

function press the – key until OFF appears on the large display.

E. Repeat steps C and D for setting other function values.

Press the REPROG key after setting all relevant functions to store the changes in the

program. The control then automatically switches back to operation mode and the machine

is ready for use. The newly set values are now the new default values

PROGRAMMING

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

No comments

Premier ULTRA 5 User Manual Page 15